Error Messages - Excell H4 Series User Manual

EXCELL PRECISION CO., LTD.
Key Function
:
, ~
:
:
:
ZERO or
:
TARE or
:
: Totalizing the quantity or weight.
: Clear the stored totalizing memory. Or shift the digit pointer to right.
Different keys for different models:
: Press this key to clear preset.
: Press this key to switch the unit : kg or lb
:
: Press this key and release it within 3 seconds, then user can increase or

1-4 Error Messages

E1  zero value is too high (OMIL or NTEP ＞10% full scale)
E2  zero value is too low (OMIL or NTEP ＜10% full scale)
E6  Internal value ＞700,000 (use in factory calibration)
E7  Internal value ＜100,000 (use in factory calibration)
oL  The weight value is over 9d of the maximum capacity. (d = division)
unStAbLE  Internal value is unstable (Unstable over 10 seconds after pressing
key)
TARE
03005XXX/03006XXX
Number key for setting the unit weight, quantity and etc.
Clear key to clear the digits on the display.
Unit weight key for setting the unit weight of sample.
Press this key, the display returns to 0.
Press this key to deduct the weight of container. Or shift the digit pointer to left.
Pre-setting the upper limit of count. If the calculated count is larger than the
limit, the scale sends a warning sound. Or use this key to confirm the setting.
Press this key to preset the unit weight of sample. Or use this key to enter the
setting mode.
decrease the number of decimal places. Or press this key over 3 seconds,
the display resolution will change from 1/3,000 to 1/30,000 temporarily. The
display resolution will return back to 1/3,000 after 5 seconds.
7
or
ZERO
ZSME200000060