Installing And Removing The Bobbin Case; Installing The Bobbin - JUKI AMS-210E-1306 Instruction Manual

4-4. Installing and removing the bobbin case

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.

4-5. Installing the bobbin

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
3
1
2
2.5 cm
4
5
3
1
2
1) Open hook cover 1 .
2) Raise latch 3 of bobbin case 2 , and remove
the bobbin case.
3) When entering bobbin case, insert it with the
latch tilted until "click" sounds.
If it is not fully inserted, bobbin
case 2 may slip off during sewing.
1) Set the bobbin 1 into bobbin case 2 in the
direction shown in the figure.
2) Pass the thread through thread slit 3 of bobbin
case 2 , and pull the thread as it is. By so
doing, the thread will pass under the tension
spring and be pulled out from thread hole 4 .
3) Pass the thread through thread hole 5 of the
horn section, and pull out the thread by 2.5 cm
from the thread hole.
If the bobbin is installed in the bobbin
case orienting the reverse direction,
the bobbin thread pulling out will
result in an inconsistent state.
– 16 –