Threading The Machine Head; Installing And Removing The Bobbin Case - JUKI K-1E Instruction Manual

3. Threading the machine head

3.T T h h r r e e a a d d i i n n g g t t h h e e m m a a c c h h i i n n e e h h e e a a d d
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by
abrupt start of the
Pull out the thread by approximately 40mm from the needle after threading through the needle.
Caution!
1.When the silicon oil is used, thread through thread guide for silicon ❶ (Optional).
2.For thick thread, pass the thread through one hole only of needle bar thread guide ❷

4. Installing and removing the bobbin case

4.Installing and removing the bobbin case
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by
abrupt start of the
1)Open hook cover ❶ .
2)Raise latch ❸ of bobbin case ❷ , and remove
the bobbin case.
3)When installing the bobbin case, fully insert it
into the shuttle shaft, and close the latch!
Caution!
If it is not fully inserted, bobbin case ❷may slip
off during sewing.
– 7 –