Configuration (Standalone); Automatic Mixed Effect Mode; Sound-Active Mixed Effect Mode; Sound Sensitivity - Chauvet DJ GigBAR MOVE + ILS User Manual

Configuration (Standalone)

Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.

Automatic Mixed Effect Mode

To run the GigBAR MOVE + ILS in automatic mode, follow the instructions below.
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until AUTO is highlighted.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Program.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from the Auto Program options: Mix 1–4, Spots, Strobe, Laser,
Derby, Par, S+SP, L+SP, LS, D+SP, DS, DL, P+SP, PS, PL, PD, PS+SP, PL+SP, PLS, PD+SP,
PDS, PDL, DLS+SP, PLS+SP, PDS+SP, PDL+SP, or PDLS.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select Mode.
9. Press <ENTER>.
10. Use <UP> or <DOWN> to select between Snap (snap transition between programs) and Fade
(fading transition between programs).
11. Press <ENTER>.
12. Use <UP> or <DOWN> to select Speed.
13. Press <ENTER>.
14. Use <UP> or <DOWN> to select to adjust the program speed, from 0–99.
15. Press <ENTER>.

Sound-Active Mixed Effect Mode

To run the GigBAR MOVE + ILS in sound-active mode, do the following:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SOUND is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Program.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from the Auto Program options: Mix 1–4, Spots, Strobe, Laser,
Derby, Par, S+SP, L+SP, LS, D+SP, DS, DL, P+SP, PS, PL, PD, PS+SP, PL+SP, PLS, PD+SP,
PDS, PDL, DLS+SP, PLS+SP, PDS+SP, PDL+SP, or PDLS.
7. Press <ENTER>.

Sound Sensitivity

To set the sound sensitivity on the GigBAR MOVE + ILS, follow the instructions below:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SOUND is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Sensitivity.
5. Press <ENTER>
6. Use <UP> or <DOWN> to set the sound sensitivity from 0–99.
7. Press <ENTER>.
• The product will only respond to low frequencies of music (bass and drums).
• The laser will black out when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.

Dimmer

To adjust the dimmer on the GigBAR MOVE + ILS, do the following:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until AUTO or SOUND is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Dimmer.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to set the dimmer from 0–255.
7. Press <ENTER>.
Page 16 GigBAR MOVE + ILS User Manual Rev. 3
Operation