Table of Contents
Advertisement
Available languages
Available languages
3. Setup
AC Power
The GigBAR MOVE + ILS has an auto-ranging power supply, and it can work with an input voltage range
of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
•
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Fuse Replacement
1.
Disconnect the product from power.
2.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3.
Pry the fuse holder out of the housing.
4.
Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
5.
Insert the fuse holder back in place and reconnect power.
Spare fuse holder
(inside safety cap)
Disconnect the product from the power outlet before replacing the fuse.
Always replace a blown fuse with one of the same type and rating.
Power Linking
The product provides power linking via the outlet located in the back of the product. See the diagram below
for further explanation.
Power-Linking Diagram
Power
Source
You can power link up to 2 GigBAR MOVE + ILS products on 120 VAC or up to 4
GigBAR MOVE + ILS products on 230 VAC.
ILS Connection
ILS (Integrated Lighting System) provides 4 modes that synchronize with the GigBAR MOVE + ILS: Modes
1 and 3 synchronize with side 1 of the GigBAR MOVE + ILS, whereas modes 2 and 4 synchronize with
side 2 of the GigBAR MOVE + ILS. When linked, effects will sync with the most similar effect on the
selected side of the GigBAR MOVE + ILS: Kinta effects will sync with one of the kintas, moving heads will
sync with one of the moving heads, and wash effects will sync with one of the pars. Laser effects will sync
with the laser, and strobe effects will sync with the strobe effects regardless of ILS mode.
Page 10
nd
st
2
1
Product
Installed fuse
(held by plastic clip)
Safety cap
rd
3
Product
Product
GigBAR MOVE + ILS User Manual Rev. 3
Setup
Additional
Products
Advertisement
Table of Contents
