Tipping Hazards - JLG 100SX Operator's And Safety Manual

SECTION 1 - SAFETY PRECAUTIONS
Table 1-1.Minimum Safe Approach Distances (M.S.A.D.)
Voltage Range
(Phase to Phase)
0 to 300V
Over 300V to 50 KV
Over 50KV to 200 KV
Over 200 KV to 350 KV
Over 350 KV to 500 KV
Over 500 KV to 750 KV
Over 750 KV to 1000 KV
DANGER: DO NOT maneuver machine or personnel inside PROHIB-
ITED ZONE. ASSUME all electrical parts and wiring are ENERGIZED
unless known otherwise.
• Maintain a clearance of at least 10 ft (3m) between any
part of the machine and its occupants, their tools, and
their equipment from any electrical line or apparatus
carrying up to 50,000 volts. One foot additional clear-
ance is required for every additional 30,000 volts or
less.
DO NOT MANEUVER MACHINE OR PERSONNEL INSIDE PROHIB-
ITED ZONE (MSAD). ASSUME ALL ELECTRICAL PARTS AND
WIRING ARE ENERGIZED UNLESS KNOWN OTHERWISE.

Tipping Hazards

• Ensure that the ground conditions are adequate to
support the maximum tire load indicated on the tire
load decals located on the chassis adjacent to each
wheel. Do not travel on unsupported surfaces.
1-4
MINIMUM SAFE APPROACH
DISTANCE
in Meters (Feet)
AVOID CONTACT
3 (10)
5 (15)
6 (20)
8 (25)
11 (35)
14 (45)
– JLG Lift –
• The user should be familiar with the driving surface
before driving. Do not exceed the allowable sideslope
and grade while driving.
• Do not elevate platform or drive with platform elevated
while on a sloping, uneven, or soft surface. Ensure
machine is positioned on a firm, level and uniformly
supported surface before elevating platform or driving
with the platform in the elevated position.
• Before driving on floors, bridges, trucks, and other sur-
faces, check allowable capacity of the surfaces.
• Never exceed the maximum work load as specified on
the platform. Distribute loads evenly on platform floor.
Keep all loads within the confines of the platform,
unless authorized by JLG.
3121809