Electrical Specifications; Recommended Operating Conditions; Absolute Maximum Ratings - CMOSTEK CMT2310A Manual

1 Electrical Specifications

The measurement conditions are: V
sequence, matching to 50 Ω impedance and 0.1% BER if nothing else stated. All measurement results are obtained using the
evaluation board CMT2310A-EM if nothing else stated.

1.1 Recommended Operating Conditions

Parameter
Operating supply voltage
Operating temperature
Supply voltage slope

1.2 Absolute Maximum Ratings

Parameter
Supply voltage
Interface voltage
Junction temperature
Storage temperature
Soldering temperature
ESD rating
[2]
Latch-up current
Notes:
[1]. Exceeding the Absolute Maximum Ratings may cause permanent damage to the equipment. This value is a pressure
rating and does not imply that the function of the equipment is affected under this pressure condition, but if it is exposed to
absolute maximum ratings for extended periods of time, it may affect equipment reliability.
[2]. The CMT2310A is a high performance RF integrated circuit. The operation and assembly of this chip should only be
performed on a workbench with good ESD protection.
= 3.3 V ， T
DD OP
Table 1. Recommended Operating Conditions
Symbol
V
DD
T
OP
Table 2. Absolute Maximum Ratings
Symbol
V
DD
V
IN
T
J
T
STG
Last for at least 30 seconds
T
SDR
Human body model (HBM)
Human body model (HBM)
@ 85 ℃
Caution! ESD sensitive device.Precaution should be used when handling the device in order to
prevent performance degradation or loss of functionality.
= 25 °C ， F = 433.92 MHz, sensitivity is measured by receiving a PN9
RF
Condition
Condition
Rev 1.0E | Page4/50
Min. Typ. Max.
1.8 3.6
-40 85
1
[1]
Min. Typ.
-0.3 3.6
-0.3 3.6
-40 125
-50 150
255
-2 2
-100 100
www.cmostek.com
CMT2310A
Unit
V
℃
mV/us
Max.
V
V
℃
℃
℃
kV
mA