Chapter 9 Events And Alarms; Configure Motion Detection Alarm; Configure Video Tampering Alarm - HIKVISION AE-MD5043 User Manual

Mobile video recorder

Hide thumbs Also See for AE-MD5043:

Table of Contents

When motion detection alarm is configured, once a motion event is detected, the device starts to

record and multiple linkage actions will be triggered.

Step 1 Go to Configuration > Event > Basic Event > Motion Detection.

Step 2 Select Channel No.

Step 3 Draw detection area.

1) Click Draw Area.

2) In preview area, drag to draw the detection area.

3) Click Stop Drawing.

Step 4 Set Sensitivity.

Step 5 Configure arming schedule. For detailed steps, refer to Configure Arming Schedule.

Step 6 Configure linkage method. For detailed steps, refer to Configure Linkage Actions.

Step 7 Click Save.

A tampering alarm is triggered when the camera is covered and the monitoring area cannot be

viewed. Linkage actions, including audible warning, alarm output, can be set to respond.

Step 1 Go to Configuration > Event > Basic Event > Video Tampering.

Step 2 Select Channel No.

Step 3 Draw detection area.

1) Click Draw Area.

2) In preview area, drag to draw the detection area.

3) Click Stop Drawing.

Step 4 Configure arming schedule. For detailed steps, refer to Configure Arming Schedule.

Step 5 Configure linkage method. For detailed steps, refer to Configure Linkage Actions.

Step 6 Set Sensitivity.

Step 7 Click Save.

Mobile Video Recorder User Manual

Chapter 9 Events and Alarms

Table of Contents