Table of Contents
Advertisement
The function analyzing driver's behavior, including smoking, fatigue driving, talking on phone, etc.
The recorder will trigger warning when these behaviors are detected.
Smart Device Driving Behavior Configuration
Only the recorder with A in model name supports driving behavior detection function. One recorder
supports analyzing one channel at a time.
Calibrate Camera Position
Calibrate network camera position before enabling driving behavior detection.
Before You Start
Add the network camera in your recorder.
Go to Configuration > VCA > Driving Behaviors > IPC Position Calibration.
Step 1
Step 2 Select Channel No.
Step 3 Adjust the network camera position to make the driver face image appear in the red frame
and his chin is above the yellow line.
Configure Driving Behavior Analysis
Set the driving behavior analysis parameters according to actual situation to lower false detection
rate.
Step 4 Go to Configuration > VCA > Driving Behaviors > Driving Behaviors.
Step 5 Select Camera No.
Step 6 Check behaviors to analyze and configure their parameters.
Step 7 Alarm Time
Step 8 Device alarms when the corresponding driving behavior lasts for the set time.
Confidence Interval
Available for on-the-phone detection and smoking detection. The higher the value is, the lower the
false detection rate. You are recommended to use the default value.
Stop Detections when Driving in Low-Speed
The feature is valid when GPS positioning succeeded. When the vehicle speed is lower than the set
value, all the driving behavior analyses will stop.
Voice Alarm
When it is checked, device will send out voice alarm when a checked behavior is detected.
Mobile Video Recorder User Manual
Chapter 8 Driving Behavior Configuration
32
Advertisement
Table of Contents
