Pre-Dive Checklist; Post-Dive Checklist; Installing The Optional Recording Extender - Boxfish 360 Owner's Manual

Pre-Dive checklist

Inspect each dome for scratches and dirt, inside and outside.
•
Erase Memory cards with the Boxfish App. Please do not format memory
•
cards in the camera, or the synchronised autostart will not work.
Open the top lid.
•
Press each camera's power button for two seconds to power on.
•
Confirm each camera battery is fully charged.
•
Confirm each camera is set to the same aperture, ISO speed, shutter angle,
•
white balance, and exposure compensation.
Press the start/stop button and confirm all cameras are starting up.
•
Press the start/stop button again to stop the recording.
•
Confirm the O-ring is in place, undamaged, and free of debris.
•
Close the top lid.
•
Ensure all three latches have locked securely.
•
Place the camera inside the neoprene bag to protect the domes while getting
•
into the water.
Enter the water.
•
Remove the neoprene bag.
•
Clear bubbles from domes to ensure unobstructed video recording.
•

Post-Dive checklist

Place the housing inside the neoprene bag to protect the domes while getting
•
out of the water.
Remove the camera from water.
•
Rinse the camera with fresh water after use; wipe the camera with a towel
•
before opening.
Open the top lid.
•
Press each camera's power button for two seconds to turn it off.
•
Connect the AC power adapter to charge the camera batteries.
•
Remove the memory cards and insert them into the triple card reader.
•
Place a towel over the housing while charging to prevent dirt and dust
•
entering the housing.
Use the Boxfish App to copy the video files onto your computer and create the
•
stitching project.
Make a backup of the video files before erasing the memory cards.
•

Installing the optional Recording Extender

1. Remove the batteries from the Boxfish 360 Recording Extender.
2. Remove the top lid from the Boxfish 360 Spherical Camera.
3. Place the Boxfish 360 Recording Extender inside the top lid, making sure not
to pinch any cables.
4. Position the three included screws into the mounting holes.
All rights reserved. Information and specifications may change at any time without notice.
Version 1.8.0, 2018-01-18
9