Turning On - Boxfish 360 Owner's Manual

Turning on

The camera can only be turned on and off outside the water, with opened lid.
1. Remove the top lid.
2. Locate the power buttons for each camera and press them for three seconds.
3. The cameras will power up.
4. Check the display of each camera to ensure:
1. Each camera is in video mode
2. Each camera has sufficient battery charge.
3. Each camera has sufficient recording time left.
4. Each camera shoots at the same frame rate .
5. Each camera is set ot the desired exposure compensation
6. No errors are shown (red), like a faulty or missing card.
5. Verify the cameras are all set to the desired aperture (See "Adjusting the
aperture"
6. The Boxfish 360 is now ready for recording.
With optional recording extender:
7. Turn the Boxfish 360 Recording Extender on. The fans will start spinning.
8. Connect the power lead to the DC plug inside the camera housing.
9. Carefully place the lid on top of the housing. Feed the extra cable length in the
space between camera lens and camera body of camera #2.
10. Ensure the lid sits securely and no cable or O-ring is pinched.
11. Fasten the latches.
If you would like to record timelapse photos, briefly press the power button of each
camera again to switch them into photo mode.
You can set the timelapse recording interval and duration with the Boxfish App.
All rights reserved. Information and specifications may change at any time without notice.
Version 1.8.0, 2018-01-18
13