Starting/Stopping The Recording - Boxfish 360 Owner's Manual

Starting/Stopping the recording

Video recording
1. Turn all cameras on (see "Turning On").
2. Locate the large start/stop button on the outside of the housing.
3. Press the start/stop button firmly once and release it.
4. You will hear a beep while the button is pressed.
5. After three seconds the cameras will start recording and a short beep is
emitted.
6. The short be can sometimes be useful to verify camera synchronization in
post.
7. If this is followed by a very long beep, the cameras were not turned on.
8. Verify that all cameras are recording by looking for the red blinking recording
LED visible through each dome.
9. You can stop the recording by pressing the start/stop button again.
Timelapse recording
1. Turn all cameras on (see "Turning On").
2. Tap each camera's power button once to switch them into photo mode.
3. Locate the large start/stop button on the outside of the housing.
4. Press the start/stop button firmly twice and release it.
5. You will hear a beep while the button is pressed, and three beeps after the
double press.
6. The cameras take a photo every five seconds. You can change the recording
interval with the Boxfish App (Tab "Settings", Slider "Photo Interval").
7. Verify that all cameras are recording by looking for the red blinking recording
LED visible through each dome.
8. You can stop the recording by pressing the start/stop button again.
All rights reserved. Information and specifications may change at any time without notice.
Version 1.8.0, 2018-01-18
14