Boxfish 360 Quick Start Manual

Boxfish 360
Lighting Rig | Quick Start Guide
Setup
1. Place the lighting rig on a flat surface.
2. Apply silicone grease to the charge ports on each camera.
3. Unscrew the thumb wheels by two full turns or 3-4mm and rotate the lights
into position (see over page).
4. Tighten the thumb wheels back down finger tight.
5. Place the rig onto the Boxfish 360 with light arms in gap between domes
(see image).
6. Secure in place with the Boxfish float package.
7. Reverse these steps to pack back into the carry case.
Charging
Connect the six way charger to each of the lights. For further information, see the
included owner's manual.
Flotation
For additional floation, a second Boxfish float package can be added to the
bottom of the Boxfish 360. Alternatively, a second float package can be split into
two and attached to the top of the first one by unscrewing the two halves.
All rights reserved. Information and specifications may change at any time without notice. June 2020.