Instructions for Installation and Care of Arctic Cat / Textron Prowler Pro
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you
are happy with the product before removing protective film. Once the film is removed you cannot return
Be sure to read these instructions thoroughly before opening and installing the windshield.
1. Check over the parts included in the cartons with the parts list shown below:
1 ¼" Stainless Bolts
1 3/4" Stainless Bolts
2" Stainless Bolts
Small Washers
Metal Brackets
Plastic Thumb Nuts
Lock Nuts
Nylon spacers
1 ¼" Black Spacer
Plastic Slide Fasteners
167" side Bulb Gasket
Small Polycarbonate piece
Vent Sliders
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2. Start by pulling it out of the box; find a clean area to lay it down and install the hardware.Next take the
136" Side Bulb rubber gasket and starting at one end firmly place along the bottom edge of the
windshield.You will need to peel back the protective film from the edge to install the gasket. If you
leave the bulk of the protective film on while installing you can avoid scratching the windshield. Ensure
that the gasket is seated fully home on the along the edge to insure a good fit of the windshield.
3. Next take the two vent sliders and install then to the inside surface of the windshield. Start by installing
the handle first. Take the 2" bolt, black spacer and lock nut and install them into the round holes on the
sliders. Make sure that the bolts are installed on opposite sides of the sliders so that you have mirror
images of each other when done. The pictures on the next page show how to install the bolts.
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Full Aero-Vent Polycarbonate Windshield
AC-PRO-WD05
the product for a full refund.
4 each
2 each
2each
8 each
4 each
4 each
4 each
2 each
2 each
14 each
1 each
1 each
2 each