Regulator Removal - Wolf CG365P/S Manual

REMOVE THE BURNER VALVE (continued)
1
4 Use a / " combination wrench to remove the main burner
2
tube.
1
5 Use a / " combination wrench to remove the manifold
4
screw.
TIP: If removing the gas tubes from the valve is difficult, remove
the gas tubes from the orifice holder, then remove the gas tube
from the valve.
BURNER VALVE INSTALLATION
Install the Burner Valve
1 Install the burner valve into the manifold.
1
2 Use a / " combination wrench to install the manifold screw.
4
1
3 Use a / " combination wrench to install the main burner
2
tube.
5
4 Use a / " combination wrench to install the simmer burner
16
tube.
5 Install the black wire onto the normally-open (NO) terminal.
6 Install the red wire onto the common (C) terminal.
Install the Receptacle
1 Install the receptacle onto the burner valve.
2 Use a Phillips screwdriver to install the screws into the
receptacle.
Install the Light Module
1 Connect the AC-DC rectifier to the light module.
2 Insert the tabs of the light module into the receptacle.
3 Push the light module into the receptacle.
828389 REV. A 06/2018
CG Contemporary Gas Cooktop Service Manual
Install the Unit
Install the unit.
Install All Bezels
To install each bezel:
1 Insert the bezel into the unit.
2 Use a
Install All Knobs
Push each knob onto each valve shaft.
Install All Burner Caps
Install all burner caps onto the burner assemblies.
Install All Burner Grates
Place all burner grates onto the cooktop.
TIP: Place the side grates first and the center grate last.

REGULATOR REMOVAL

To remove the regulator, first remove the burner grates, burner
caps, knobs, and bezels. Uninstall the unit, and then remove the
burner assemblies and burner pan.
Turn off the power and gas to the product before
starting this procedure.
If the gas line is not long enough to stay connected
when the unit is pulled out of the opening, the gas
may need to be disconnected.
24
3
/ " socket to install the bezel on the unit.
4
WARNING
CAUTION
service.subzero.com