Wolf CG365P/S Manual page 14

Install All Burner Assemblies
To install each burner assembly:
1 Attach the electrode wire to the igniter.
2 Place the burner assembly into the burner pan.
3 Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
Install the Unit
Install the unit.
Install All Bezels
To install each bezel:
1 Insert the bezel into the unit.
3
2 Use a / " socket to install the bezel on the unit.
4
Install All Knobs
Push each knob onto each valve shaft.
Install All Burner Caps
Install all burner caps onto the burner assemblies.
Install All Burner Grates
Place all burner grates onto the cooktop.
TIP: Place the side grates first and the center grate last.
RECEPTACLE REMOVAL
To remove the receptacle, first remove the grates, burner caps,
knobs, and bezels. Then, remove the unit from the installation
and remove the light modules.
WARNING
Turn off the power to the product before starting this
procedure.
CAUTION
If the gas line is not long enough to stay connected
when the unit is pulled out of the opening, the gas
may need to be disconnected.
828389 REV. A 06/2018
CG Contemporary Gas Cooktop Service Manual
Remove All Burner Grates
Lift all burner grates from the unit.
TIP: Remove the center grate first.
Remove All Burner Caps
Remove all burner caps from the burner assemblies.
Remove All Knobs
Pull all of the knobs away from the unit.
13
service.subzero.com