Burner Assembly Removal - Wolf CG365P/S Manual

LIGHT MODULE REMOVAL
To access the light modules on a Contemporary model, remove
the knobs and bezels.
WARNING
Turn off the power to the product before starting this
procedure.
Remove the Knob
Pull the knob away from the unit.
Remove the Bezel
3
Use a / " socket to remove the bezel from the unit.
4
Remove the Light Module
1 Pull the light module forward out of the receptacle.
828389 REV. A 06/2018
CG Contemporary Gas Cooktop Service Manual
2 Disconnect the AC-DC rectifier wire connector from the light
module.
LIGHT MODULE INSTALLATION
Install the Light Module
1 Connect the AC-DC rectifier to the light module.
2 Insert the tabs of the light module into the receptacle.
3 Push the light module into the receptacle.
Install the Bezel
1 Insert the bezel into the unit.
2 Use a
Install the Knob
Push the knob onto the valve shaft.

BURNER ASSEMBLY REMOVAL

To remove a burner assembly, first remove the burner grate and
burner cap.
The unit might be supported by the burner pan. The
unit must be uninstalled if more than one burner
assembly or the burner pan is being removed.
Turn off the power to the product before starting this
procedure.
7
3
/ " socket to install the bezel on the unit.
4
CAUTION
WARNING
service.subzero.com