Wolf CG365P/S Manual page 30

Remove the Burner Cap
Remove the burner cap from the burner assembly.
Remove the Burner Assembly
1 Use a T-15 Torx bit to remove the screws holding the burner
assembly to the orifice holder.
2 Lift the burner assembly from the burner pan.
3 Remove the electrode wire from the igniter.
4 Remove the burner assembly from the unit.
Igniter
Remove the Electrode Wire
1 On the bottom of the unit, use a
remove the screw holding the igniter bracket to the burner
box.
2 Lower the screw side of the igniter bracket.
3 Disconnect the electrode wire from the spark module.
828389 REV. A 06/2018
CG Contemporary Gas Cooktop Service Manual
Burner Cap
Burner Assembly
Electrode Wire
1
/ " nut driver or socket to
4
4 Remove the electrode wire from the unit.
ELECTRODE WIRE INSTALLATION
Install the Electrode Wire
1 Feed the electrode wire from the burner assembly opening
down to the spark module.
2 Anchor the electrode wire to the burner assembly.
3 Connect the electrode wire to the spark module.
4 Raise the igniter bracket into the burner box.
5 Use a Phillips screwdriver to install the screw through the
igniter bracket in the base of the unit.
Install the Burner Assembly
1 Attach the electrode wire to the igniter.
2 Place the burner assembly into the burner pan.
3 Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
Install the Burner Cap
Place the burner cap onto the burner assembly.
Install the Burner Grate
Place the burner grate onto the cooktop.
29
service.subzero.com