How To Replace The Vacuum Belt And Headlight Bulb - Titan T4000.2 Owner's Manual

CAUTION: Unplug the vacuum cleaner before performing any of
these steps.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the low position by pressing the foot pedal
release twice while reclining the handle. Turn the vacuum over.
2. Remove the two screws holding the bottom plate in place (Fig. 1).
3. Remove the bottom plate.
How to Replace the Belt
1. Turn the vacuum cleaner over and remove the bottom plate as described
in the above section.
2. Remove the belt guard (Fig. 2). Remove the brushroll by pulling it
straight out (Fig. 3).
3. Remove the belt from the brushroll.
4. Loop a new belt over the motor pulley (Fig. 4) and over the end of the
brushroll.
5. Stretch the belt while inserting the brushroll back into the nozzle housing.
6. Reinsert the belt guard.
7. Spin the brushroll by hand to make sure it turns smoothly and the new
belt is properly aligned.
8. Replace the bottom plate by hooking the front end of the plate into the
two ribs on the front end of the nozzle housing. Press the bottom plate
into place and fasten it with the two screws.
NOTE: To ensure maximum cleaning efficiency, check the belt regularly to
ensure it is in good condition. Replace the belt if it is stretched, cracked or
if excessive slipping is occurring.
How to Replace the Headlight Bulb
Model T4000
1. Turn the vacuum cleaner over and remove the bottom plate as described
in the above section.
2. To remove the bulb, grasp it gently and pull it straight out.
3. Install a new bulb by pushing it straight into the socket.
4. Replace the bottom plate as described in the above section.
How to Replace the Vacuum Belt
11
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5