Cleaning And Maintenance - Domo DO42101SV Instruction Booklet

CLEANING AND MAINTENANCE

 Before cleaning switch off the appliance and make sure that it is not plugged in.
 Never attempt to clean the device or its parts with solvents, petrol or abrasives that could
damage the surface of the device.
 Before using the vacuum cleaner, make sure that all components are correctly assembled.
 Always use a vacuum cleaner with all filters. If all filters are not properly seated and
cleaned, you may lose suction power or damage the engine.
 Do not put the filters in the dishwasher or in the washing machine. Do not use a hair dryer to
dry.
CLEANING THE DUST RESERVOIR
1. Remove the hand-held vacuum cleaner from the stick vacuum and press the release
button on the dust reservoir on the hand-held vacuum cleaner.
2. Remove the dust reservoir from the motor section. Then take the filters out of the
dust reservoir.
3. Empty the dust reservoir. The dust reservoir, the filter and the HEPA filter can be
cleaned under running water. Do take care to dry them completely before using them
again in the machine. We advise replacing the filters regularly to ensure an optimal
operation of the machine. Dirty filters will reduce the suction power drastically. After
every cleaning, clean the dust reservoir and the filters to extend the life span of your
machine.
CLEANING THE FLOOR BRUSH
1. Remove the floor nozzle from the upright vacuum cleaner. Press the release button at
the back of the floor nozzle and remove it from the machine.
2. Click on the release button on the left of the floor brush.
3. Remove the rotating floor brush from the floor nozzle. Remove hairs and other dirt
that have wrapped around the floor brush. If you do not clean the floor brush
regularly, it will become damaged and your machine will become unusable.
4. The rotating floor brush may be rinsed off under running water. Make sure that it is
completely dry before using it.
5. Place the floor brush back into the floor nozzle when it is clean. Click the closure
valve back into place to close it.
6. Push the nozzle back onto the stick. The machine is now again ready for use.
Note: Stuck hairs can damage the machine or your floor. Always remove the hairs stuck on
the brushes.