Cleaning And Maintenance - Domo DO214SV Instruction Booklet

DO214SV
must always be completely empty before the machine is recharged. So wait until the
machine stops during use before recharging it. Repeat this full battery charge cycle
regularly, followed by complete draining of it to extend the life of the battery.
When the battery is fully charged, you can use the appliance for max. 30 min.
Note: when the lamp blinks (2 times per second) there is something wrong and the
machine must be taken in for repair.
USE
• The appliance can remain in upright position due to
the lock-position. (see picture). Before use, remove the
appliance from the lock-position. Place one foot on the
floor nozzle and pull the handle backwards. The floor
nozzle is now maneuverable.
• Press the on-off switch on the handle to turn the machine on. When you switch on
the machine, the rotating floor brush at the bottom of the floor nozzle will begin
to turn. This will cause the dirt in the opening to be shifted and thereby vacuumed
up. The dirt will be collected in the dust reservoir.
• The machine is equipped with a safety which will ensure that the machine shuts
itself off if, for example, objects which are too large are sucked up, or if fingers
become tangled in the floor brush. This is for personal safety and to protect the
motor.

CLEANING AND MAINTENANCE

Cleaning the dust reservoir:
Clean the dust reservoir after every use.
1. Press the unlock button of the dust reservoir. Remove
the dust reservoir from the main body.
2. Pull the filter holder (A) from the dust reservoir (B)
3. Empty the dust reservoir.
4. Open the filter holder by turning it anti-clockwise. The
white triangle points to the unlock symbol.
5. Remove the filter from the holder en clean this. The
filter may be rinsed under running water. Afterwards,
let it air-dry.
6. Make sure the filter is fully dried before putting it
back in place.
7. Put the filter back in the holder. Put the lid of the
filterholder back in place and turn it clockwise. The
white triangle points to the lock symbol.
8. Put the filterholder into the dust reservoir and place it back into the stick vacuum
cleaner.
36
A
B