Description Of The Parts; Changing The Dust Bag; Maintenance; Instructions For Use - Domo DO7246S Instruction Booklet

DO7246S

DESCRIPTION OF THE PARTS

9 9
1. On/off switch
2
5
3
2. Cable rewinder
1
3. Suction power regulation
4. Lid of the accessories
5. Indication for bag change
7
6. Clip for opening the dust bag compartment
7. Handle
8. Floor brush
6
9. Flexible hose
4
8
ASSEMBLY
Attach the hose to the hose connection of the vacuum cleaner.
Attach the metal tube to the hose.
Connect the fl oor brush to the metal tube.

INSTRUCTIONS FOR USE

1. Button to rewind the cable :
Pull the cord out of the appliance as far as necessary. Make sure you don't exceed the
red marking on the wire. Keep hold of the plug during the rewinding of the cord. You
can press the button with your foot to rewind the cable.
2. Suction power regulation :
Use the knob to adjust the suction power of your vacuum cleaner.
3. When the green light around the knob turns red, you should check the following :
- Is the dust bag full ? If so change it.
- Is the dust bag blocked ? If so remove the blockage immediately.

CHANGING THE DUST BAG

The vacuum cleaner cannot be used without the dust bag. When the dust bag is full or
damaged you need to replace it immediately.
1. Remove the fl exible hose.
2. Open the dust bag compartment.
3. Remove the dust bag and place a new one in the correct position.
4. Close the dust bag compartment and make sure the cover is closed properly.

MAINTENANCE

1. Motor fi lter
The motor fi lter is situated in the dust bag compartment. You need to change or clean
the motor fi lter when it is visible dirty. This can improve the effi ciency of your
vacuum cleaner and prolong the life. It is recommended to at least clean the motor
fi lter twice a year.
1. Open the dust bag compartiment
16