Maintenance - Pentair HEBEFIX 100 Instruction Manual

ENGLISH
tilation hole of the lid.
6. Press the cover over the tank edge until the snap connec-
tions click into place. Fix the cable(s) with the clips and the
screws. Screw down the cover with the screws and cover them
with the plugs. Now the Hebefix is ready for service.
Mounting special float (accessory)
The special float (JP 44795 or JP44207) for the pump is requi-
red for dewatering a shower tray. A shower can be connected
only in conjunction with a dewatering pump U3KS, U5KS or
U6KS. To prevent a backpressure of water into the shower tub,
observe the min. shower installation height.
In connection with a US pump type the special float allows to
lower the switch levels, e.g. for washingmachines.
Mounting automatic alarm (accessory)
The automatic alarm AGR (JP44893) or the alarm AWR
(JP44897) signalizes an unacceptably high water level. The
AWR simultaneously turns off the connected washing machine
or dishwasher.
Open the marked position in the cover Ø 13 mm and mount the
alarm switch corresponding to the operation instructions.
The installation of a U3KS, U5KS and U6KS with a low level
switch requires, the fastener (JP28191) for the alarm unit.

MAINTENANCE

WARNING!
Before every work on the pump: pull main plug!
The unit is free of maintenance. In case of a deteriorate pump
performance remove all sediments from the tank.
For pump maintenance see manual of the pump.
Change of the activated carbon filter
• 1x year at least
• in case of annoyance caused by bad smell
• in case of water penetration through the filter.
8