Stopping The Engine - Nakayama PRO MB6100 Manual

EN
Handling Tips
Adjust the handlebar height to a comfortable position (waist height for normal tilling)
Should the machine jerk forward while tilling, press down the handlebars, if the machine will not move
forward, move the handlebars from side to side.
Turn: The proper method of negotiating a turn during a tilling operation is to lower the handlebars to bring
the gravity centre toward the rear and then make the turn. This will permit a turn to be made with relative
ease.
Normal Operating Angle
Lower the handle slightly so the front of the machine is raised about 6-8o.
To get the maximum advantage from the tiller, try to hold the machine at the angle shown while you are
tilling the ground.
CAUTION:
- Do not use the tiller with a rotor whose diameter is in excess of 300mm.
- Operating the tiller on grades could cause the tiller to tip over .
- Allowing any one to operate this tiller without proper instruction may result in injury.
- Wear study, full coverage footgear. Operating this tiller with bare feet, or with open toe shoes or sandals increases your risk of injury.
- Do not use the tiller in the night .
- Be sure to use two people to transport the tiller from one place to another without using a carrier.
- When the rotor is clogged with mud, pebble etc, immediately stop the engine and clean the rotor in a safe place. Be sure to wear heavy gloves when cleaning
the rotor.
- To prevent damage, check the tiller for any signs of damage or other faults each time the tiller is used after it has been operated.

Stopping the engine

In case of emergency
Turn the engine switch to OFF.
(1) OFF
(2) ENGINE SWITCH
In normal use
·Release the clutch lever to DISENGAGED position
and shift lever is in neutral position.
(1) CLUTCH LEVER
(2) DISENGAGED
(1)
(2)
2. Turn the engine switch to OFF.
(1) OFF
(2) ENGINE SWITCH
12
WWW.NAKAYAMATOOLS.COM
1. Move the throttle lever fully to the right.
(1) THROTTLE LEVER
3. Turn the fuel valve to OFF
(1) FUEL VALVE
(2) OFF