Terminal Interface; Payload Mounting - FLIR E Series User Manual

4.7.2 - Terminal Interface

To test the PTU using the serial interface:
1. Configure the RS-232 or RS-485 port on the host computer as described in
page 16.
2. Power up the PTU. A boot message will appear on your terminal screen and the unit will begin a
reset cycle. An asterisk (*) appears on your screen when the reset cycle is finished. If the PTU did not
reset properly, please refer to the troubleshooting instructions below.
3. Please see "Serial Command List" on page C-4
Command Reference Manual for a complete list of commands and associated parameters and other
usage instructions.

4.8 - Payload Mounting

The PTU payload bracket system can be configured in a number of ways to support a variety of payloads
including cameras, lasers, antennas, and other equipment. Figure 3 shows all bracket configurations
available for the PTU-E46.
WARNING: FAILURE TO FOLLOW ALL PAYLOAD MOUNTING INSTRUCTIONS COULD
RESULT IN A STRUCTURAL FAILURE THAT MAY RESULT IN DEATH, PERSONAL INJURY,
AND/OR DAMAGE TO THE UNIT.
The following guidelines apply to all payload mounts:
• The maximum payload mounting screw size is ¼".
• Always use washers, lock washers, etc. as appropriate.
• If the PTU is being mounted in an outdoor location, use corrosion-resistant hardware (such as
stainless steel).
• Apply thread locking compound to all screws, such as Loctite® 242, which is suitable for applications
that are field serviceable since it is easily removable with common hand tools and works with both
stainless and plated metals. Consider other compounds for high-shock/vibration applications where
field service is not a concern.
Chapter 4: Installation & Setup
for a list of basic commands, and the Pan-Tilt E Series
Copyright 2016, FLIR Commercial Systems, Inc.
"Serial Connection" on
25