Step 5; Reset Procedure - Uplift Desk V2 4-Leg Assembly Instructions

Standing desk

Table of Contents

Step 5

A. With the help of a friend, flip the desk upright. Re-

fer to Step 1 and reverse those instructions.

B. Move the desk back to its location.

• If you have casters installed, make sure the

casters are not locked and roll it to the loca-

tion.

• If you are using the pre-installed leveling

glides, carefully lift the desk with two or more

people and move it to its location - DO NOT

drag the desk as this may cause damage to

the desk and floor.

C. Once the desk is in position, reinstall any accesso-

ries that had been removed and plug the power

cord back into the outlet.

D. Before use, perform the reset procedure below.

This is an important step.

Before using the desk, you must first perform this

Reset Procedure:

• Press and hold the Down Button until the desk

stops at its lowest position, then release.

Note: On the Advance Paddle keypad, press

down on the paddle.

• Press and hold the down button again for 30

seconds, then release.

Note: On the Advance Paddle keypad, the

word "RESET" will appear at this point.

Note: On other UPLIFT keypads with display,

the letters "ASr" will appear at this point.

• Press and hold the Down Button one more time

until the desk lowers slightly, rises and stops,

then release the button. The reset is complete

and the desk is ready for use.

Table of Contents

Do you have a question about the V2 4-Leg and is the answer not in the manual?