Clutch Pedal; Gear Oil Replacement - Suzuki 2010 Kizashi Owner's Manual

INSPECTION AND MAINTENANCE
Rear differential (i-AWD)
(1) Oil filler and level plug
Tightening torque
Manual transaxle
Transfer
Rear differential
7-23
Gear Oil Level Check
The manual transaxle, transfer gears (i-
AWD CVT) and rear differential (i-AWD)
are lubricated with gear oil. To check the
(1)
gear oil level in any of the above locations,
use the following procedure:
1) Park the vehicle on a level surface. Set
parking brake and stop the engine.
2) Remove the oil filler plug (1).
For the manual transaxle;
3) If gear oil flow from the plug hole, the oil
level is correct. Reinstall the plug.
If gear oil do not flow from the plug
hole, add oil through the filler plug hole
57L71009
until a little oil flow from the plug hole.
For the transfer and rear differential;
3) Check the inside of the hole with your
finger. If the oil level comes up to the
bottom of the plug hole, the oil level is
Oil Filler Plug
correct. If so, reinstall the plug.
27 Nm
4) If the oil level is low, add gear oil
(19.5 lb-ft)
through the filler plug hole (1) until the
(2.7 kg-m)
oil level reaches the bottom of the filler
hole.
23 Nm
(16.6 lb-ft)

Gear Oil Replacement

(2.3 kg-m)
Since special procedures, materials and
tools are required, it is recommended that
you trust this job to your authorized
SUZUKI dealer.

Clutch Pedal

Check the clutch pedal for smooth opera-
tion and clutch fluid level from time to time.
If clutch dragging is felt with the pedal fully
depressed, have the clutch inspected by
your SUZUKI dealer. If the clutch fluid level
is near the "MIN" line, fill it up to the "MAX"
line with SAE J1703 or DOT3 brake fluid.
57L71010