Frame Hooks - Suzuki 2010 Kizashi Owner's Manual

®
Using HomeLink
To operate, simply press and release the
®
programmed HomeLink button. Activation
will now occur for the trained device (i.e.
garage door opener, gate operator, secu-
rity system, entry door lock, home/office
lighting, etc.). For convenience, the hand-
held transmitter of the device may also be
used at any time. In the event that there
are still programming difficulties or ques-
tions, contact HomeLink
www.homelink.com or 1-800-355-3515.
®
Erasing HomeLink Buttons
To erase programming from the three but-
tons (individual buttons cannot be erased
but can be "reprogrammed" as outlined
below), follow the step noted:
Press and hold the two outer HomeLink
buttons until the indicator light begins to
flash-after 20 seconds. Release both but-
tons. Do not hold for longer that 30 sec-
®
onds. HomeLink is now in the train (or
learning) mode and can be programmed at
any time beginning with "Programming
®
HomeLink " – step 2).
Reprogramming a Single
®
HomeLink Button
To program a device to HomeLink
®
HomeLink button previously trained, fol-
low these steps:
1) Press and hold the desired HomeLink
button. DO NOT release the button.
2) The indicator light will begin to flash
after 20 seconds. Without releasing the
®
HomeLink
®
at
gramming HomeLink
For questions or comments, contact
®
HomeLink at www.homelink.com or 1-
800-355-3515.
®
OTHER CONTROLS AND EQUIPMENT
®
using a
®
button, proceed with "Pro-
®
" – step 2).

Frame Hooks

Front hook (1)
1) Take out the necessary tools (jack bar,
wheel nut wrench and tow hook) from
the onboard tool set.
2) Use the end of the jack bar (a) wrapped
with a cloth (b) to open the front tow
hook cover (c).
(c)
(b)
3) Insert the tow hook (e) into the tow
hook receptacle (d) and screw the hook
in as far as it can be turned by hand.
(a)
57L51037
5-96