Removing And Replacing The Ilo Service Port Assembly In Sff - HP HPE ProLiant DL325 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing the iLO Service Port assembly in SFF

Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack.
•
Remove the server from the rack.
•
5. Remove the access panel.
6. Remove the SFF front I/O assembly.
7. Remove the iLO Service Port assembly in SFF.
a. Remove one T-15 screw.
b. Remove the iLO Service Port assembly.
Removal and replacement procedures
70