Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing the optical drive
Prerequisites
Before you perform this procedure, make sure that you have T-10 Torx screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5. Remove the access panel.
6. Disconnect all cables from the optical drive.
7. Remove the optical drive:
•
LFF
Removal and replacement procedures
62
Advertisement
Table of Contents
