Table of Contents
Advertisement
3. Install the cable management arm into the rack.
For more information, see the installation instructions that ship with the option.
4. Connect peripheral devices to the server.
For information on identifying connectors, see Rear panel components.
5. Connect the power cord to the rear of the server.
6. Use the hook-and-loop strap to secure the power cord.
7. Connect the power cord to the power source.
Installing the access panel
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Place the access panel on top of the server with the latch open.
Allow the panel to extend past the rear of the server approximately 1.25 cm (0.5 in).
2. Push down on the latch.
The access panel slides to a closed position.
3. Tighten the security screw on the latch, if needed.
Removal and replacement procedures
39
Advertisement
Table of Contents
