Siemens SITRANS L Operating Instructions Manual page 146

Parameter reference
Electronics Temperature (3.3.)
To access the following parameters via AMS Device Manager see Electronics Temperature
under Maintenance & Diagnostics (LTB) (Page 85).
Minimum Value (3.3.1.)
The minimum recorded internal electronics temperature, reported in units defined in
Temperature Units (2.3.4.).
Maximum Value (3.3.2.)
The maximum recorded internal electronics temperature, reported in units defined in
Temperature Units (2.3.4.).
Peak Values (3.4.)
Minimum Measured Value (3.4.1.)
The minimum recorded Sensor value, reported in units defined in Unit (2.3.1.).
Maximum Measured Value (3.4.2.)
The maximum recorded Sensor value, reported in units defined in Unit (2.3.1.).
Service (4.)
Note
Default settings in the parameter tables are indicated with an asterisk (*) unless explicitly
stated.
Master Reset (4.1.)
Note
• The following parameters are not reset by any reset type: Write Protection, PIN to Unlock,
Auto False Echo Suppression Range, Learned TVT.
• While an FF Object Dictionary Reset is in progress, do not perform an action using the local
display interface until the reset is complete. This could cause a temporary loss of
communications.
146
SITRANS LR250 with FOUNDATION FIELDBUS
Operating Instructions, 09/2021, A5E32221411-AH