Table of Contents
Advertisement
Overview of the use of keys
Changing numeric values
•
To change a number, use the Move Cursor key to the digit to be changed.
•
If the new number will be negative, start with the sign using the Make Character Higher key.
•
Move the cursor to each digit and change the value using either the Make Character Higher or Lower keys.
•
Once the value of the number is correct use the Enter key to store the new value into memory, or use the
Cancel key to leave the number at its previous value and go back.
Changing names
•
To change the name used to identify an input or output, use the Move Cursor key to the character to be
changed and change it using either the Make Character Higher of Lower keys.
•
Upper case and lower case letter, numbers, a blank space, period, plus and minus symbols are available.
•
Move the cursor to the right and modify each character.
•
Once the word is correct, use the Enter key to store the new value into memory, or use the Cancel key to
leave the word at its previous value and go back.
Choosing from a list
•
Selecting the type of sensor, the units of measure of an input, or the control mode used for an output, the
selection is picked from a list of available options.
•
Use the Page Up or Down keys to highlight the desired option, and then use the Enter key to store the new
option into memory, or use the Back/Return key to leave the option at its previous value and go back.
Hand-Off-Auto relay mode
•
Use the left or right Move Cursor keys to highlight the desired mode
•
In hand mode the relay is forced on for a specified amount of time and when that time is up the relay returns
to its previous mode.
•
In off mode the relay is always off until taken out of off mode.
•
In auto mode the relay is responding to control set points.
•
use the Confirm key to accept the option, or the Back/Return key to leave the option at its previous value and
go back.
STARTUP
Initial startup
After having mounted the enclosure and wired the unit, the controller is ready to be started. Plug in the controller
and turn on the power switch to supply power to the unit. The display will briefly show the model number and
then revert to the normal summary display. Press the home key if necessary to get to the home screen.
24
W W W . B A L T I M O R E A I R C O I L . E U
Advertisement
Table of Contents
