Table of Contents
Advertisement
4.
Use the direction lever to select the direc-
tion of table travel, then plug the power feed
power cord into an appropriate receptacle.
5.
Flip the ON/OFF switch up to turn the power
feed ON.
6.
Adjust the speed dial to move the table at the
correct speed for your operation.
Note: Power feed rates are difficult to pre-
cisely adjust. We recommend that you exper-
iment with different dial settings to find the
feed rate that best works for your operation.
7.
When you are through using the power feed,
leave the direction lever in the center or
neutral position, and flip the ON/OFF switch
down to turn the power feed OFF.
Always keep the table locked in place
unless controlled movement is required
for your operation. Unexpected table move-
ment during operations could cause the
cutter to bind with the workpiece, resulting
in personal injury, and possible damage to
the cutter and workpiece.
Model G0731 (Mfd. Since 01/17)
Positioning
Headstock
The head tilts 45° to the left or right and the
turret rotates 360° around the column (see
Figures 27–28).
Any time the head has been tilted or rotated, you
must tram the spindle with the table when setting
the headstock back to the 90° position. This is the
only way to ensure precision milling results later.
Refer to Tramming Spindle on Page 41 for more
information.
Figure 27. Example of head tilted 45° to the left.
Figure 28. Example of head and turret rotated
45° to the left.
Tools Needed
Wrench 17mm.................................................... 1
Qty
-27-
Advertisement
Table of Contents
