Advertisement
MAINTENANCE
SELF - MAINTENANCE PROCEDURES
BATTERY
Battery is located below the cover frame R. The
electrolyte level of the battery must be maintained to
avoid damages to the battery. To check the electrolyte
level, follow the procedure
1. Park the vehicle using the centre stand on
a firm and flat surface.
2.
Remove
the cover frame R (refer page no. 3 ).
3. Inspect the battery electrolyte level. It should be
between the minimum and maximum level.
4. If the electrolyte level is below the minimum level,
add only distilled water upto the maximum level
by removing the cap.
given below
:
0
5. Reinstall the cap and clean the battery thoroughly,
apply petroleum jelly to the battery terminals to
protect it from corrosion.
lncase of any abnormality or for removal of battery
from the vehicle, contact TVS Motor Company
Authorised Distributor or Dealer / Authorised Service
Center.
Caution
Once the battery is initially charged, never add diluted
sulphuric acid. Use only distilled water for topping up.
Never add tap water.
Never check the battery charge by shorting the terminals.
Always connect the positive terminal first (red wire) and
then negative (black wire) to avoid sparking.
The inversion of the battery wires can damage the battery
and the recharging system.
Do not obstruct, bend or change the routing of battery air
vent tube. Make sure that the vent tube is firmly attached
to the battery and the other end is open and clear.
If the motorcycle is to remain unused for a long time (a
month or longer), it is advisable to disconnect the battery
cables or have the battery removed by skilled personnel.
43
Advertisement
