General Procedure; Unpacking The Device; Installing The Device In Hazardous Locations - Siemens SIMATIC NET RUGGEDCOM RSG2100F Installation Manual

Installing the Device
2.1 General Procedure
of a tool, lock and key, or other means of security, and controlled by the authority
responsible for the location.
2.1

General Procedure

The general procedure for installing the device is as follows:
IMPORTANT
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
2.2

Unpacking the Device

When unpacking the device, do the following:
1.
2.
3.
Note
If any item is missing or damaged, contact Siemens for assistance.
2.3

Installing the Device in Hazardous Locations

The RUGGEDCOM RSG2100F is designed to comply with the safety standards
for Class I, Division 2, Zone 2 hazardous locations where concentrations of
flammable gases, vapors or liquids may be present, as opposed to normal operating
environments.
8
Review the relevant certification information for any regulatory requirements.
For more information, refer to
Mount the device.
Connect the failsafe alarm relay.
Connect power to the device and ground the device to safety Earth.
Connect the device to the network.
Configure the device.
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
"Approvals (Page 39)".
Installation Manual, 04/2022, C79000-G8976-1344-11
RUGGEDCOM RSG2100F