Mitsubishi Electric s-MEXT-G00 006 Technical Manual page 32

TM_s-MEXT_ME28relC_00_12_19_EN
Mask of the terminal
--------------- P22.17
Set heat. 1 working h.
to maintenance: 00000h
--------------- P22.18
Set heat. 2 working h.
to maintenance: 00000h
--------------- P22.19
Set humid. working h.
to maintenance: 00000h
--------------- P22.21
Reset alarm by
supervision system: N
--------------- P22.55
Enable BMS1 offline
management:
--------------- P22.56
Timeout BMS1 for
detect offline: 015s
--------------- P22.79
Air flow
alarm delay time: 045s
--------------- P22.80
Clogged filters
alarm delay time: 008s
--------------- P22.83
Type flood alarm: A-M
--------------- P22.84
Type phase sequence
alarm rearm: A-M
--------------- P22.85
Type f/smoke alarm: A-M
Insert a NEW
SERVICE
password
0000
Evolution+
Code ME 28.00 EN
HW pCO5+S
NAND 50MB
Flash 2MB + 7MB + 4MB
Ram 2048KB
Boot 05.01 Bios06.21
Technical manual
Description
Parameters for setting
Step 1 heater operating hours for maintenance setpoint
Step 2 heater operating hours for maintenance setpoint
Parameter for setting the humidifier working hours for maintenance setpoint
Parameter for configuring the alarm reset with supervision (N:disabled - Y:enabled)
Parameters for configuring BMS port 1 offline management and timeout.
N
Parameter for selecting the delay time before signalling of the air flow alarm
Parameter for selecting the delay time before signalling of the dirty filters alarm
Parameter for setting if the flooding event should cause a notification or an alarm, and the reset type
Parameter for setting the phase sequence error alarm reset type
Parameter for setting the Fire/Smoke alarm reset type
Sets a new "Service" password.
Warning: The value set in this field is the one and only to access the service menu
This mask contains the reference information of the software [Code ME 28.00 EN].
The closed padlock symbol shows that the board is provided with its propriety software.
The second part of the mask shows information about the hardware: size (S), memories (NAND, Flash, Ram) and
the versions of the installed operating system (boot and bios).
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
32
N. Par.
22.17
22.18
22.19
22.21
22.55
22.56
22.79
22.80
22.83
22.84
22.85