Appendix - HoMedics HL158B1-BD Instruction Manual

Appendix

 Guidance and manufacturer's declaration – electromagnetic emissions
The device is intended for use in the electromagnetic environments listed below, and
should only be used in such environments:
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
 Guidance and manufacturer's declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environments listed below, and
should only be used in such environments:
Immunity test
Electrostatic ± 8 kV contact
discharge (ESD) discharge
IEC 61000-4-2
± 15 kV air
discharge
Power frequency
(50/60 Hz) 30 A/m
magnetic field 50 or 60 Hz
IEC 61000-4-8
Compliance
Group 1
Class B
Not Applicable
Not Applicable
IEC 60601 Compliance
test level
± 8 kV contact
discharge
± 15 kV air
discharge
30 A/m
50 or 60 Hz
-33-
Electromagnetic environment – guidance
RF energy is used only to maintain device's
operation. Therefore, its RF emissions are so
low that it's not likely to cause any interference
in nearby electronic equipment.
The device is suitable for use in all
establishments, including domestic
establishments, and those directly connected
to the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Electromagnetic environment –
level
In the case of air discharge testing, the
climatic conditions shall be within the
following ranges:
Ambient Temperature:15℃~35℃
Relative Humidity: 30%~60%.
Power frequency magnetic fields should be
at levels characteristic of a typical location
in a typical commercial or hospital
environment.
guidance