Wireless; Wireless Settings - TP-Link TL-WR940N User Manual

Chapter 6
• MAC Address
• Type
to configure IP address manually.
• IP Address
(factory default - 192.168.0.254).
• Subnet Mask
255.255.255.0 is used as the subnet mask.
• Gateway
Note:
• If you have changed the IP address, you must use the new IP address to log in.
• If you select
• If the new IP address you set is not in the same subnet as the old one, the IP Address pool in the DHCP
Server will be configured automatically, but the Virtual Server and DMZ Host will not take effect until they
are re-configured.
6. 4.
6. 4. 1.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router.
2. Go to
3. Configure the basic settings for the wireless network and click Save.
Downloaded from ManualsNet.com
- The physical address of the LAN ports. The value can not be changed.
- Either select Smart IP(DHCP)
- Enter the IP address in dotted-decimal notation if your select
- An address code that determines the size of the network. Normally
- The gateway should be in the same subnet as your IP address.
Smart IP(DHCP), the DHCP server of the router will not start up.

Wireless

Wireless Settings

Wireless > Wireless Settings.
search engine
Configure the Router in Repeater Mode
to get IP address from DHCP server, or Static IP
Static IP
97