570REM-TX8-10GE
User manual
4.5.
ENCODER CONTROL
Figure 4-8 : WebEASY
- Encoder Control (Part 1)
®
4.5.1. Encoder Configuration
Latency Mode: This control allows the user to set the latency of the encoding process. It should be
displayed if any product feature support J2k Encoder is enabled and the number of index to be
displayed depends on the number of J2K enabled. User configurable latency settings are Standard,
Medium, low and Ultra low.
Color Specification: This control allows the user to set the color specification of the encoding process,
it should be displayed if any product feature support J2K encoder is enabled and the number of index to
be displayed depends on the number of J2K encoder enabled.
Total TS Bit Rate: This parameter allows the user to select the output TS Bit rate. Note: Card will
adjust the bitrate for video and other pids based on these settings. Unit is kbps.
Page 18
Revision 1.0