Basic Safety Notes; Intended Use; Not Intended Use; Constructional Changes - SCHUNK FT-AXIA80-DUAL SI-75-4 Assembly And Operating Manual

Basic safety notes

2.1 Intended use

2.2 Not intended use

2.3 Constructional changes

2.4 Spare parts

8 01.00 | FT-AXIA | Assembly and Operating Manual | en | 1517831
2 Basic safety notes
The product is a machine component designed for measuring
forces and moments (FT=force torque) in six directions. The
product converts the mechanically acting forces into electrical
measured values and can transmit these to a customer PC or
control system via various interfaces.
• The product may only be used within the scope of its technical
data, } 3 [/ 13].
• When implementing and operating components in safety-
related parts of the control systems, the basic safety principles
in accordance with DIN EN ISO 13849-2 apply. The proven safety
principles in accordance with DIN EN ISO 13849-2 also apply to
categories 1, 2, 3 and 4.
• The product is intended for installation in a machine/automated
system. The applicable guidelines for the machine/automated
system must be observed and complied with.
• The product is intended for industrial and industry-oriented use.
• Appropriate use of the product includes compliance with all
instructions in this manual.
• Any utilization that exceeds or differs from the appropriate use
is regarded as misuse.
Implementation of structural changes
By conversions, changes, and reworking, e.g. additional threads,
holes, or safety devices can impair the functioning or safety of the
product or damage it.
• Structural changes should only be made with the written
approval of SCHUNK.
Use of unauthorized spare parts
Using unauthorized spare parts can endanger personnel and
damage the product or cause it to malfunction.
• Use only original spare parts or spares authorized by SCHUNK.