Thermistor For Cube Control - Hoshizaki DIM-40DE-HC Service Manual

14. THERMISTOR FOR CUBE CONTROL

1) Unplug the ice dispenser or disconnect the power source.
2) Remove the top panel, front panel and pipe cover (rear).
3) Remove the connector K4 on the controller board, referring to "12. [b] REPLACEMENT".
4) Unscrew and remove the thermistor holder and thermistor, located on the evaporator
(front side).
5) Install the new thermistor in the reverse order of the removal procedure, by using a
sealant (high-thermal conduct type). See Fig. 13.
Note: Recommended sealant is KE4560RTV, manufactured by Shin-Etsu Silicones.
When other type of sealant used, the cube size and performance will be
changed. Do not use silicone sealant as this will insulate the thermistor.
* Thermistor and leads are FRAGILE.
HANDLE WITH CARE.
* Leads
Sealant
Holder
Holder
Screw
* Thermistor
Fig. 13
67
Sealant
Holder
Evaporator