Table of Contents
Advertisement
No
Item
h4 Error log
h5 Software version
h6 Default model code
* To clear the model code, press the service 1 and service 2 switches together for 15
seconds (for controller board replacement and setting error correction only).
[d] MODEL CODE SETTING MODE
Note: Use this mode only when the controller board is replaced or the model code
setting needs to be corrected.
1) When
the service 1 switch is pressed for more than 3 seconds, the display mode
starts and the display shows "n1".
2)
Press the service 1 or service 2 switch to have "h6" in the display.
3)
Press the reset switch. The current memorized model code appears in the display.
4)
Press the service 1 and service 2 switches together for 15 seconds. The display
shows "00". When the controller board P01873-02 is used, the hyphen on the top left
lights up.
5)
Press the service 1 switch
service 2 switch to increase the second digit. The digit changes in the following order:
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, F, H, J, L, N. Set the proper model code
according to the model code list below. When a preset model code is displayed, the
dot on the bottom right lights up.
6) When the chosen preset model code is displayed, press the reset switch to store the
board memory (the display shows "on" and the machine will then always start up with
this memorized program as default).
* To check the current memorized model code, view in the display mode (follow
steps 1) to 3) above).
Display up to 5 errors from latest to oldest for 1 sec
ON, 0.5 sec OFF, "- -" at the end, then back to latest
error. In case of less than 5 errors, display oldest
error, "- -", then back to latest one.
< Display >
e.g. E5 (latest), E4, E3, E2, E1 (oldest)
(latest)
E
off E4 off E3 off E2 off E1 off
For Ver. 1.0A, display "01." "0A" "01." alternately for
1 sec ON, 0.5 sec OFF.
Display set model codes from "00" to "FF"
(hexadecimal, 256 patterns)
to increase the first digit in the 7-segment display, and the
25
Description
Clear
Yes
(oldest)
- -
No
No
(*)
Advertisement
Table of Contents
