Thermistor For Cube Control - Hoshizaki IM-30CWNE Service Manual

14. THERMISTOR FOR CUBE CONTROL

1) Unplug the icemaker or disconnect the power source.
2) Remove the top and front panels.
3) R e m o v e t h e c o n n e c t o r C N 1 3 o n t h e c o n t r o l l e r b o a r d , r e f e r r i n g t o " 1 3 .
CONTROLLER BOARD".
4) Unscrew and remove the thermistor holder and thermistor, located on the evaporator
(front side).
5) Install the new thermistor in the reverse order of the removal procedure, by using a
sealant (high-thermal conduct type). See Fig. 22.
Note: Recommended sealant is KE4560RTV, manufactured by Shin-Etsu Silicones.
When other type of sealant used, the cube size and performance will be
changed. Do not use silicone sealant as this will insulate the thermistor.
** Thermistor and leads are FRAGILE.
HANDLE WITH CARE.
** Leads
Sealant
Holder
Holder
Screw
** Thermistor
Fig. 22
87
* Insert aluminum tape or foil
between holder and sealant.
Sealant
* Aluminum Tape
Holder
Evaporator