Power on CIS
Confirm boot up of CIS
"Device discovery process" by
frame grabber control software
Control CIS by
frame grabber control software
(Refer to Chapter 5 for details on
control functions)
(Refer to Appendix A
for the register table)
TM-XJ101C
4-1 Startup procedure
CoaXpress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
GenICam® is a trademark of EMVA (European Machine Vision Association)
•
Supply 5V power and 24V power
* Supply both 5V and 24V power at the same time, or 5V first.
•
Status LED will turn to green after boot up.
Boot up period after power on is;
L4: Approx. 10 seconds, L5: Approx. 12 seconds,
L6: Approx. 16 seconds.
(If CoaXpress® cable is not connected properly, status LED
may switch to light in red and orange alternately after
booted up. For details on status LED, refer to 4-2.)
•
This CIS supports GenICam®.
•
By "Device discovery process", register definition file
(XML file) in CIS, is automatically downloaded to frame grabber.
(Refer to the Grabber board manual for the "Device
discovery process")
•
After the download, the register information is shown
on the control software of the Grabber board. CIS can be
controlled by changing the register values.
( Refer to the Grabber board manual, to check how to
show and / or to change the register information.)
58
© Mitsubishi Electric Corporation