Mitsubishi Electric KD Series User Manual page 67

Address
Register name
6010 PixelFormat
4014 LinkConfig
5-2-4 Output Mode Setting
[Function]
Switch image output format, and select among "24bit
color", "30bit color","8bit mono", and "10bit mono"
Switch bit-rate of output data and number of output
channel
Bit-rate: CXP6 ,CXP5 , CXP3
CXP6=6.25 ,CXP5=5 ,CXP3=3.125 [Gbps/ch]
Number of output channel: Single (1ch), Dual (2ch), Quad
(4ch)
1) Output mode is complied with CoaXpress® .
TM－XJ101C
5-2 Setting③: Output mode setting
R/W Val
0x0401,
Switch image output format
0x0402,
R/W 0x0401:24bit RGB color , 0x0402:30bit RGB color
0x0101,
0x0101:8bit mono, 0x0102:10bit mono
0x0102
0x40048,
0x40040, Set bit-rate of output data and number of output channel
0x40038, 0x40048:CXP6_X4,0x40040:CXP5_X4,0x40038:CXP3_X4
0x20048, 0x20048:CXP6_X2,0x20040:CXP5_X2,0x20038:CXP3_X2
R/W 0x20040, 0x10048:CXP6_X1,0x10040:CXP5_X1,0x10038:CXP3_X1
0x20038,
0x10048, ※CXP6=6.25 ,CXP5=5 ,CXP3=3.125 [Gbps/ch]
0x10040,
0x10038
X1=Single(1ch) ,X2=Dual (2ch) ,X4=Quad(4ch)
[Remark]
1) The frame grabber you use needs to be capable of the
Output Format you select on this product.
2) When changing "PixelFormat" and "LinkConfig", please
change the settings to all of CXP signal channels
including slave channel.
3) The setting of "LinkConfig" after power ON always
becomes "CXP6_X4".
4) Because "Output Mode Setting" interacts with Line
Frequency and number of output pixel, please set this
setting based on your calculation for each setting.
CoaXpress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
Result
© Mitsubishi Electric Corporation
Initial
0x0401
0x40048
67