Mitsubishi Electric KD Series User Manual page 48

3-2-1 Preparation by users
① DC5V power cable
Following cable connectors are recommended.
Housing : DAU-15S-F0R(JAE）
Contact socket
CIS connector is DAU-15P-F0R (JAE), and the contact pin
is 030-50635 (JAE)
Pin assignment of CIS connector is as shown below
Pin
L4
No
V1 V3 V1
1
2
3
4 +5V +5V +5V
5
6
7
NC NC NC
8
9
10
11
12 GND GND GND
13
14
15
TM－XJ101C
3-2 Preparation
: 030-50634(JAE）
V2
Name
L5 L6
V2 V3 V1 V2
+5V
(NC)
+5V
+5V +5V +5V
+5V
(NC)
NC NC NC NC
GND
(NC)
GND
GND GND GND
GND
(NC)
"NC" on the pin assignment means no connection. Therefore,
the same pin assignment of V1 can be applied with the pin
assignment of V2,V3.
Set the pairs of +5V and GND as follows, when you connect
pins.
1 pin and 9 pin, 2 pin and 10 pin, 3 pin and 11 pin,
4 pin and 12 pin, 5 pin and 13 pin, 6 pin and 14 pin,
7 pin and 15 pin
V3
【 Reference 】CIS internal connections (V1 in L4)
1 2
Symb
ol
V3
Image processing
画像処理基板
+5V VDD
board
【Remarks】
When you use a cable in the field as the power cable, confirm
NC
the connection and the cable length and standard carefully.
Cable resistance 120mΩ or less between the power supply
and CIS is recommended.
(Cable standard AWG22： approx. 2m, AWG20： approx. 3m,
GND GND
AWG18： approx. 5m)
3 4 5 6 7 8 9 10 11 12 13 14 15
Image processing
画像処理基板 Ｉ/Ｆ基板
board
© Mitsubishi Electric Corporation
V1
I/F board Control board 制御基板
48