RuggedCom RuggedSwitch RS900L Installation Manual page 18

8-port managed switch with eovdsl uplinks

Table of Contents

All manuals and user guides at all-guides.com

NOTE: RuggedCom does not recommend the use of copper cabling of any length for critical real-

time substation automation applications. However, transient suppression circuitry is present on all

copper ports to protect against damage from electrical transients and to ensure IEC 61850-3 and

IEEE 1613 Class 1 conformance. This means that during the transient event communications

errors or interruptions may occur but recovery is automatic.

RuggedCom also does not recommended to use these ports to interface to field devices across

distances which could produce high levels of ground potential rise, (i.e. greater than 2500V) during

line to ground fault conditions.

Rev101

Table of Contents