Ethernet Ports; Rj11 Ethernet Over Vdsl Port; Figure 9 - Rj11 Port Pin-Out And Leds; Table 3 - Rj11 Port Pin-Out - RuggedCom RuggedSwitch RS900L Installation Manual

3 Ethernet Ports

3.1 RJ11 Ethernet over VDSL Port

3.1.1 Overview
The Ethernet over VDSL (EoVDSL) port on RS900L operates in pairs with one configured as the
Master and the other as the Slave. In VDSL literature the terms Central Office (CO) or Line
Termination (LT) are used interchangeably for the Master and the terms Customer Premise
Equipment (CPE) or Network Termination (NT) are used interchangeably for the Slave.
Configuration of Master or Slave mode is done through the RuggedSwitch Operating System.
The unit contains one EoVDSL data port that allows connection to Category 3 (CAT-3) unshielded
twisted-pair (UTP) cable with RJ11 male connectors. The figure below shows the RJ45 port pin-out
and LEDs.

Figure 9 - RJ11 port pin-out and LEDs

Pin Signal
3 Ring
4

Table 3 - RJ11 port pin-out

Status LED
Mode
Link / Act

Table 4 - RJ11 port LED description

©
2007 RuggedCom Inc. All rights reserved
All manuals and user guides at all-guides.com
Tip
Colour
Green
Green
14
Activity
On Master Mode
Off
Solid Link Established
Blinking
Comments
Slave Mode
Tx Activity
Rev101