Table of Contents
Advertisement
Base Instrument Cluster Display
Screen Setup Options:
Upper Right
Current
(MPG,
Trip B Distance Trip A Distance
L/100km,
or km/L)
Base Instrument Cluster Display
Screen Setup Options:
Center
None
Compass
Time
Range
Current
(MPG,
Trip A Distance Trip B Distance
L/100km,
or km/L)
Audio Menu
Menu Title
Title
Defaults
Restore
Cancel
Speed Warning — If Equipped
Push and release the up
button until Speed Warning is highlighted in the
instrument cluster display. Push and release the
OK button to enter Speed Warning. Use the up
or down
arrow button to turn the Speed Warning
ON or OFF, then push and release the OK button to
confirm the selection. If the ON status is selected,
use the up
or down
desired speed, then push the OK button to set the
speed for the Speed Warning. A Speed Warning
light will illuminate in the instrument cluster, with a
number matching the set speed, with a pop-up
message to inform the driver that the Speed
Outside Temp
Warning has been set to the desired speed. Each
Average
time the set speed is exceeded, a single chime will
(MPG,
sound and a pop-up warning message will display.
L/100km,
If the set speed is exceeded more than 2 mph
or km/L)
(3 km/h), a continuous chime will sound for up to
10 seconds, or until the speed is no longer
exceeded. The telltale in the instrument cluster will
also change from white to yellow, and a pop-up
warning message will pop-up on the instrument
cluster display.
Digital Speed
NOTE:
Speed Warning is unavailable while KeySense is
in use.
GETTING TO KNOW YOUR INSTRUMENT PANEL
B
ATTERY
M
ODE
or down
arrow
R
EDUCTION
This vehicle is equipped with an Intelligent Battery
Sensor (IBS) to perform additional monitoring of
the electrical system and status of the vehicle
battery.
In cases when the IBS detects charging system
arrow button to set the
failure, or the 12 Volt vehicle battery conditions are
deteriorating, electrical load reduction actions will
take place to extend the driving time and distance
of the vehicle. This is done by reducing power to or
turning off non-essential 12 Volt electrical loads.
Load reduction will be functional when the vehicle
propulsion system is active.
The vehicle may not be running depending on the
High Voltage (HV) battery State Of Charge (SOC) or
temperature. It will display a message if there is a
risk of battery depletion to the point where the
vehicle may stall due to lack of electrical supply, or
will not restart after the current drive cycle.
When 12 Volt load reduction is activated, the
message "Battery Saver On" or "Battery Saver
Mode" will appear in the instrument cluster display.
These messages indicate the vehicle battery has a
low state of charge and continues to lose electrical
charge at a rate that the charging system cannot
sustain.
S
O
/B
S
AVER
N
ATTERY
AVER
M
— E
L
ESSAGE
LECTRICAL
OAD
A
— I
E
CTIONS
F
QUIPPED
119
3
Advertisement
Table of Contents
